Isotherm Digital Temperature Control Problems. Isotherms (a) and temperature independent curves (b) of methanol Measure the voltage again with the compressor starting or running - the voltage should drop no more than 0.5V - if there is more than 0.5V drop, check all the terminals and connections carefully fort good contact, tightness and signs of corrosion. Measure the voltage at the electronic unit with the compressor off and note the voltage
Isotherms for (a) / = 0.01, (b) / = 0.05, (c) / = 0.1 and (d) / = 0.3 from www.researchgate.net
According to the Isotherm literature (linked on the Defender website), you have the ITC controller Isotherm's ISEC controller is listed as "automatic refrigeration control for high efficiency".
Isotherms for (a) / = 0.01, (b) / = 0.05, (c) / = 0.1 and (d) / = 0.3
Components making up the kit: Instructions manual Digital display Digital display support frame Digital Display The device is compatible only with control units IWM P/N SEG00002DA Secop version 101N0212 and IWM P/N SEG00030GA Secopversion 101N0510 The ITC Digital Display (Intelligent Temperature Control) clearly shows, controls and regulates the temperature in a refrigerated compartment from the exterior of a fridge/freezer cabinet, while significantly reducing the on-board power consumption
Isotherm ITC Digital Display Intelligent Temperature Control. This helps keep the keep the cold in and can reduce the amount of power used by the refrigeration unit. FWIW I can recommend fitting the digital thermostat, which comes complete with the smart energy control system that webasto / Isotherm have for this range of fridges
Temperature distributions and isotherms for different governing. I'm interested in this as well as I'm planning on buying an Isotherm fridge Digital Display The device is compatible only with control units IWM P/N SEG00002DA Secop version 101N0212 and IWM P/N SEG00030GA Secopversion 101N0510